- Description:
Superbright DIP top LED & viewing angle, high brightness output, no spot and shadow.
Colors can be chosen as Full color
Low power consumption & operating voltage, safe and energy-saving.
With IP67 protection rating.
Solid-state, high shock or vibration resistant, long lifetime, more than 50000 hours.
Easy installation with mounting holes and 3M adhesive tape on the back.
Features:
IC RGB module with WS2811/LC8806
individually Control
Programmable & SD controller
DMX512 controllable
Madrix compatible
IP67 waterproof protection
Parameter:
RGB Pixels are digitally-controllable lights you can set to any color, or animate. Each RGB LED and controller chip is molded into a 'dot' of silicone. The dots are waterproof and rugged. There are four flanges molded in so that you can 'push' them into a 12mm drill hole in any material up to 1.5mm/0.06" thick. They're typically used to make outdoor signs
Each dot is digitally controlled, with an internal 8-bit PWM LED driver (24-bit color for 16 million different shades). The pixels must be clocked by a microcontroller, we have an example code linked below that works on an Arduino, it should be simple to adapt it to any other microcontroller.
The pixels use 8mm diffused RGB LEDs, with a 120 degree beam width. The total max brightness of all LEDs is about 1600mcd but with the light more evenly distributed & mixed than a clear LED
12mm diameter (0.45") 75mm deep (1.5")
100mm
50 pieces per strand
These pixels use a WS2811 chip for full 24 bit color
5V power, 60mA maximum per pixel (LED on full white)
Check Youtube Video
|
